Planning and installation of KRAFT LED lighting for suspended ceilings

Here you will learn how to easily and smoothly install the different types and models of KRAFT LED lighting for suspended ceilings according to their specifics. With the help of detailed assembly diagrams, video instructions and a guide in a few easy steps, you can plan the execution of the project easily and without problems.

Recommendations for planning and installation of KRAFT LED lighting for suspended ceilings

With us you will find three types of KRAFT LED lighting fixtures - T-LED, G-LED and K-Led. T-LED is used for standard suspended ceilings with a T-shaped ceiling system of T-15 or T-24 profiles. G-LED is used for lamellar, lattice and other types of suspended ceilings. K-LED are universal fixtures for all types of ceilings (not just suspended).

Technological scheme for installation of KRAFT LED lighting

1. G-LED with 24mm width on the rail.

2. 15mm wide G-LED on the grid.

3. T-LED on profile T-24.

4. T-LED on profile T-15.

K-LED lighting for a suspended ceiling with a cube-shaped rail

Interactive 3D model of KRAFT LED suspended ceiling lighting

KRAFT LED T-15

KRAFT LED G-24

KRAFT K-LED

KRAFT LED T-24

KRAFT LED G-15

Planning and installation of KRAFT LED lighting for suspended ceilings

1

Lighting planning

Through the "Dialux" program, we can determine the optimal number and placement of the lamps. If you do not have the opportunity to calculate the lighting in the program, then you should proceed from approximate values: one set of KRAFT LED is designed to illuminate 8 - 10 sq. m in rooms with a height of up to 3,5 m and an area of up to 20 sq. m. m and 10 - 12 sq. m. in rooms with an area of more than 20 sq. m. In this case, distribute the lamps evenly throughout the room. In the "Dialux" program or on the room plan, we indicate the location of the lamps. We will use this schematic during assembly.

2.1

Installation of T-Led

LED profile T-LED is installed in the desired place of the suspended ceiling design instead of the standard T-profile 600 or 1200 mm.
Connecting wires are already placed in the ceiling area. It remains only to connect the kit to the driver.

2.2

Installation of G-Led

To mount the G-LED profile, first mark its position on the structure. If necessary, drill holes for the exit of the wires. Then remove the red protective tape from the back of the profile, remove the wires in the ceiling area and glue the profile to the surface of the ceiling with an open cell structure or rail.

2.3

Installation of K-Led

The driver of the K-Led lamp is hidden directly in the rail. Thanks to the new type of installation, such lamps can be installed directly on the ceiling or on any hangers, including their own wires.

3

Connecting the driver

After the LED profiles are installed, we connect them to the power supply according to the circuit diagram. The drivers can be placed at any distance from the lighting fixtures and moved to a convenient or specially designated location.